Your home inspector is worth every dollar. Book one on every purchase, no exceptions.

But know what the job usually is. A home inspection is visual and non-invasive. The inspector looks at what can be seen and reached on the day, without opening walls, taking anything apart, or moving the seller's belongings. Some inspectors go further than others, and a good one will flag anything that needs a specialist. But the baseline scope could leave gaps, and those gaps are where the expensive surprises live.

The most expensive plumbing problems in an Edmonton house live exactly where nobody can see them. Under the basement floor. Behind drywall. Out under the front yard. Here is the checklist for the stuff that hides, and what to do about each one before your conditions come off.

Jump to a section

The sewer line: get a camera in it

This is the big one. The sewer lateral runs underground from your house to the city main, and most standard inspections don't include a look inside it. The only way to see inside a buried pipe is a camera.

It matters because the pipe from your house to the property line is yours. If it is cracked, bellied, full of roots, or collapsed, the repair bill lands on you, and it can run into five figures without warning.

Get a sewer scope on any house built before roughly 1980, any house on a street with large mature trees, and any house with slow drains, repeated backups, or a sewage smell. Older Edmonton homes often have clay tile pipe, and tree roots love the joints. A camera inspection runs $400 to $600, and it shows roots, cracks, offsets, and bellies on video, so you are deciding with evidence instead of hope.

One honest caveat, because it is true: a camera can miss things. A wye hidden behind a bend or a corroded section the lens passes too fast can slip by, and we have seen jobs where the final scope of work grew after the ground was open. A camera is still the best look you can get before you buy. It just is not a guarantee.

Poly-B piping: the grey pipe that worries insurers

If the house was built between about 1985 and 1998, open the utility room door and look at the water lines. Poly-B, short for polybutylene, is grey plastic pipe, usually stamped "PB" or "PB2110," with copper crimp fittings at the corners. Check under sinks too.

Poly-B was cheap and fast to install, and Edmonton built a lot of houses with it during the 80s and 90s boom. The problem showed up over time. Chlorine and chloramine in municipal water attack the pipe from the inside, and it turns brittle and can split without warning. It was removed from the National Plumbing Code of Canada in 2005. The Government of Alberta estimates about 148,000 Alberta homes still have it.

The part that surprises buyers is insurance. Insurers may charge more, change coverage, require replacement within a set time, or decline the policy outright, and the trend is getting stricter, not looser. Before your conditions come off, call your insurer with the home's details and ask directly how they treat Poly-B. Finding out after closing is the expensive version.

Poly-B on its own doesn't have to be a dealbreaker. Price a repipe into your offer, or negotiate one. Our Poly-B page covers the replacement process, and this post breaks down the pipe materials that replace it: PEX, copper, and Kytec.

The lead service line: pre-1960 homes

Edmonton homes built before about 1960 may still have a lead water service line bringing water in from the street. You cannot see it, and a standard inspection usually won't test for it.

The good news is Edmonton has a real program for this. EPCOR launched an expanded Lead Service Line Replacement program in 2019 that removes priority lead service lines at no additional cost to the homeowner, and EPCOR's strategy is to avoid partial replacements, waiting until the homeowner is ready to replace the private side so the whole line gets done at once. EPCOR also offers a free filter for affected homes.

If you are buying an older home, ask EPCOR whether the address has a lead service line and whether it is on the replacement list. It is a five minute question that answers a health question and a budgeting question at the same time. For the bigger picture, here is where Edmonton gets its drinking water and how it is treated before it reaches your tap.

The backwater valve: required since 1989

Edmonton has required backwater valves in new construction since 1989. If the house is older than that, it may not have one, and that is the difference between a bad storm and a basement full of sewage.

A backwater valve sits on your sewer line and shuts when the city sewer surcharges in heavy rain, so sewage physically cannot reach your basement drains while the valve is closed. Ask the seller whether one is installed, and where. If there is no valve and the house is pre-1989, price one into your plans.

There is help with the cost. EPCOR's Backwater Valve Subsidy pays up to $800 toward a professionally installed valve for qualifying homes, and the pre-approval inspection is currently suspended, so the process is simpler than it used to be. You pay for the install in full, then submit the City permit sticker and paid invoice, and the subsidy comes back by cheque. Funding is first come, first served. Our installs start at $1,750 plus tax, and about 70% of homes come in right at that minimum. Details on our backwater valve page and at epcor.com.

The water heater: read the date, not the paint

A water heater can look fine and be one winter from failing. The inspector will run it and report whether it works today. What a run test won't tell you is how much life is left in it.

Find the rating plate on the tank and read the manufacture date. An old tank means a water heater replacement is coming sooner than later, and it is worth knowing before you close, not after your first cold shower in the new house. While you are there, look for rust streaks at the base, water staining on the floor, and whether the discharge pipe from the relief valve runs somewhere sensible.

The furnace: ask for the service history

Most of our gas calls are furnaces and water heaters, so this one is close to home. A furnace that runs fine on inspection day can still be overdue for service. A cracked heat exchanger is a serious problem, and a service visit is where it gets caught.

Ask the seller when the furnace was last serviced, and whether there are records. Read the manufacture date off the rating plate, the same way you would on the water heater. And check that the house has working carbon monoxide detectors, and test them while you are there.

New homeowner or not, getting a furnace ready for an Edmonton winter is a short checklist: filter, thermostat, vents, a test run, and the detector check.

The main shut-off and the sump pump: touch them yourself

Two things to check with your own hands during a showing or the inspection, because both matter most at 2 in the morning.

First, find the main water shut-off and make sure it turns. A seized shut-off valve turns a small leak into a flood while you hunt for tools. If it will not budge, that is a small fix worth doing on day one.

Second, if the house has a sump pump, pour a bucket of water in the pit and watch it run. A pump that hums and does nothing, or a pit full of silt, is a basement flood waiting for spring melt. And if the house has a sump but no battery backup, read our post on why a battery backup tops the Christmas list. The power goes out in the same storms that fill the pit.

What to do before your conditions come off

In order, while you still have leverage:

  1. Book a sewer camera scope, especially on pre-1980 homes and tree-lined streets.
  2. Call your insurer about Poly-B before conditions come off, if the house is 1985 to 1998.
  3. Ask EPCOR about a lead service line, if the house is pre-1960.
  4. Ask the seller about a backwater valve, if the house is pre-1989.
  5. Read the water heater's manufacture date and test the main shut-off yourself.
  6. Ask about the furnace's service history and age, and test the carbon monoxide detectors.

None of this means the house is a bad buy. Every Edmonton house of a certain age has a list like this. The difference between a good purchase and a painful one is knowing the list before you own it, while you can still negotiate. After closing, you can only pay.

Buying in Edmonton and want a second set of eyes on the plumbing before your conditions come off? We do camera inspections and pre-purchase plumbing checks. Call 780-717-3743 or email hello@evco.plumbing, and we will tell you straight what we find.